Boulder, CO
What are the Motor and the E relay doing when this happens?
(Topic ID: 240198)
You're currently viewing posts by Pinsider howardr.
Click here to go back to viewing the entire thread.
Quoted from lint:does not reset the drop targets
Quoted from lint:Motor is spinning and E relay is firing.
Inspect and diagnose this circuit with Alligator clip jumper wires
http://www.planetimming.com/Pinball/troubleshooting/EM%20Troubleshooting.pdf
http://www.pinrepair.com/em/index3.htm#features
Be careful because this circuit runs on 120 volts
Pinball (resized).pngQuoted from HowardR:Since the drop targets don't reset during game play or reset, the most likely culprit is the outside switch on Motor 2C
Quoted from lint:The Purple/Orange switch on 2C is open in this reset position
For a switch to work 3 things are necessary
1) When open, there should be a small space between the contact points (duh)
2) When closing, the long blade's contact point should push the short blade's contact point enough to move the short blade
3) The contact points should be clean, which they usually will be if #2 is happening
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider howardr.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
