Hi Skip,

I don’t have my documentation in front of me right now, but I found a scrap of the startup sequence in another post. The drops are reset via a score motor switch on position 2C and the S relay. I think they will be large terminals because those are big solenoids.

Good luck,
Dave

From another king pin post:

50EEF44B-137E-47CA-9632-30C2EDC1417E (resized).jpeg

That adjustment is tricky. Too much travel and you get a loud buzz because the coil stops didn’t bottom out, too little and some of the targets don’t get reset because the bar didn’t travel far enough. I had a similar problem on El Dorado and to a lesser extent on Royal Flush.

Dave