Hi all,

I'm currently rebuilding a few 10 target drop target banks. The first one I'm working on is from a Dimension, It's a brass colored unit. While disassembling, I noticed that there are no target reset bar bushings (the ones that the rod should slide through.

Do you know if they were used on this type of target bank or perhaps were added to later units. It's obvious that this bank has been removed from the machine at some point.

Thanks
-W

Thanks, My rod looks ok, but the reset bar has some pretty good grooves cut in it. This is my 1st time totally rebuilding a drop target bank, Im assuming that those grooves are from wear and aren't supposed to be there. Would it be ok to reverse the bar, so the other side of the reset bar is making contact with the fingers? Yes, my fingers are a bit worn too, I'll probably grind the edges which have flared out.

great, glad to hear that