Ok...This was a mistake I should have knon better. While moving (I lost my mind) There may have been beers involved (no excuse) and I disconnected every backbox molex connector to remove the head because it would not fit down the hallway to the basement of my new (old 1955) home. At any rate, I am well veresed in mechanical prints....electronics not so much (dont have the prints anyway) The molex connectors on Deadly weapon (to my dismay, after the fact) can be plugged in incorrectly. So...dumb long story longer, can anyone help a brother out on placing the correct molex connectors to the backbox back into the boards? It may take a facetime or pictorial effort to be sure it is correct. I know know....I should know better (read my profile) I messed up...feel free to flame, infact it might be fun.