New to trying to fix Pinball machines. I replaced the boards with new boards from Flippp!

Everything was working fine, except the controlled lights. GI lamps all seemed fine.

I was trying to understand the voltage flowing through the Tilt switch and accidentally shorted the solenoid switch to the controlled lights and the bonus lights flashed on the board.

I was trying to check the voltage at the field lamps, but had the meter set to ohms. When I touched the probe to the field light they all went out. So now the GI lamps are out.

All fuses seem good. What would have burned out?

Where would I start with the controlled lights? May have damaged something else when I shorted the solenoid.

Are there some fuses that might be hard to find?

Thanks

Bump

Bump

Thanks for responding.

I replaced all the fuses when I started working on the machine. At that point the controlled lights were still not working. After the GI lights stopped working, I checked them all.

/Chris

MasterBlaster

Ends up the GI light issue was a fuse.

Not sure what the issue with the Controlled lights is.

Thanks,
/Chris