Good afternoon everyone....

I'm a noob, got lucky and picked up a 300 a couple of weeks ago. Its beautiful, but now its stuck on Tilt.
I have checked the following:

- relays (T,H, AX). It seems as though a signal is not being sent to the backbox?
- looked for the plumb bob, did not see one. Instead I have a ball in a cage that will make contact if the level is off.
- the rotor is turning beautifully, but the reels are not moving on the back box at all

Any advice or suggestions woudl be greatly appreciated.

Thanks

Jojo

-

Sorry for the delay in responding.

I do have the schematics and have checked the H, T and AX relays.

It was running great and then just stuck on TILT.

I've wiggled the slam switch and ball tilt mechanism.

When you say "adjust" the switches....how exactly is that done? (Sorry, told you I was a noob)