Hi all. I just purchased WW. It’s my first pin and was working great until the ball went into the harpoon slot. It shot out once. The second time it fired, but not hard enough to go up the ramp. Now it won’t fire. It keeps saying “fire the harpoon” and finally the screen says call service.
Wondering if I have to replace the solenoid which one to get, where, and how do you install?
Thanks

8D733589-A644-4E99-8FF0-DF571F1525B7 (resized).jpeg

AAC09EBE-C7D3-4093-8436-887AF537E40E (resized).jpeg

Thanks for the feedback. I’ll mess around with the switch first to see if that will work. The 2 contacts on the switch are not touching would that matter?
Can you recommend tools I should have to help me replace these types of parts?

I believe this is the switch you are referring to. Looking at the ones for the flippers this one doesn’t look good.
Looks easy enough to replace so I’ll give it a shot.

85AB8B2F-A31C-437F-A399-AD42C274CAEA (resized).jpeg

Does anyone know the switch and solenoid part # I would need for the harpoon shooter?
A lot of them look alike.
Thanks

Well, I changed out the switch and coil but still no luck with the harpoon. I can rack up several points but it won’t shoot out.
Does anyone have other suggestions on what to do?

I’m posting a picture of the solenoid I got for the harpoon. I went through the single test and this is the only coil not firing. I added a block of wood in the area to keep the ball out until I can figure another solution.

ABBCC437-609B-49DC-A101-ECB8D30EA782 (resized).jpeg

Has anyone had issues with the Atoll alignment?
The Deez runs fine, but Atoll is tipped up a little too high so the balls get stuck. Not the best picture but the ball is stuck at the ramp entrance.

E62E2462-566E-4F2F-A6A3-1D39577142BC (resized).jpeg

After manually pushing it down to level the play it seems to be good now. Turned the machine on and off a few times and ball goes down the ramp now.

Hi All,
I'm looking to print a new translite for my Waterworld. I'm not a big fan of the original and the one I have is pretty scratched up. My company has a commercial grade printer as well as either clear PETG or Vinyl sheets in various thicknesses.
My only issue is I don't have any images to use. Does anyone have any images they can send me?
I appreciate any help.

Thanks Izzy. I’m going to double check the material we have to make sure this will work. The PETG I brought home today was too thick.