Gorgar
Williams, 1979You're currently viewing posts by Pinsider pintec.
Click here to go back to viewing the entire thread.
Quoted from BRIANPG:Not on power up but on game up my top pop number locks on. The wire is off now any help would be great
Reconnect Coil and remove switch inputs at upper left driverboard connector.
Turn power on start a game check if coil still comes on
Yes? then there is a short on the driverboard.
s-l640 (resized).jpgQuoted from BRIANPG:Ok I did just that. And yes it still locked on
Locks on after starting up game with disconnected special switch input:
Check Logic Signal IC 6 Pin 1 must be high.
Quoted from BRIANPG:Are you saying it should be high? What should I be reading on this. Thanks
This is confirmed using a Logic probe High should be very close around 5V of using a volt meter.
You're currently viewing posts by Pinsider pintec.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/gorgar-locked-pop-bumpers?tu=pintec and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Chicago, IL