I just purchased a Gorgar and the lower playfield is really worn. Anyone know where I can get a decent playfield, or new overlay. I would also be up for a playfield scan and I can try and make my own overlay.

Thanks

Has anyone installed a Hardtop for their Gorgar? I just bought a Hardtop and have the playfield stripped down. My question is what did you do about the inserts, did you sand until the number and letters were removed? My inserts are slightly cupped and it would take a lot of sanding to remove the letters and numbers off the inserts and might make them worse.

Thanks

Can someone take a picture of this so I can see how the wire and diode goes?

20211024_103044 (resized).jpg

I have a Gorgar that is driving my nuts. Everything works but the right flipper. We have tested the coils, they are fine. We have traced the wires for continuity all the way back to the back box, they are fine. We have tested the flipper switches and continuity from them and they are fine.

The PCB and Drive board are brand new from PinballPCB.

Anyone other ideas on what would make the right flipper not fire?

Thanks

Thanks, I emailed them

Does anyone know where I can get the side playfield glass plastic trim for Gorgar?

What is the right one to get?

Thanks