Don't worry about the screw. It rolled out of who knows where. Could even be an extra from manufacturing. Later you ever see a hole in wood without one, stick it there.

Metal clip holds cash box down with lid on, along the back edge snaps into a bracket.

Stage light cover - please contact JJP to get a new one.

Bend arm of switch up a little, towards the end, not the end where it is hooked on. Or if your button on the lockdown bar has a screw, unscrew it a little to make better contact.

Flipper - sounds like it's sticking on something. See if it has a bit of up and down play ( not back and forth ) and check plunger/plastic link/pawl for binding. And be sure the coil stop in on tight.

LTG : )

Hope we don't find out.

Hang onto that metal clip. Just in case it secures the upper playfield like the rocking playfield on POTC. I don't have a game to check.

LTG : )

You mean like for tech support ?

LTG : )

Please PM me your phone number and email address. So I can refer people to you for tech support.

LTG : )

No. It's from the flipper going up and banging the rubber ring into the metal lane guide right above it.

I'd cut the end of that metal down a bit so it doesn't cut the rubber ring.

LTG : )

I'd trim it off a bit and call it a day.

LTG : )

I just looked at the picture again.

Yes that would be better.

LTG : )

Call me. I like to be bothered.

LTG : )

Be sure the coil sleeve in there is long enough.

LTG : )

Tests - Switches - Matrixed - hit the switches, see if they work and error goes away. Or might need simple adjusting if the ball doesn't trigger them good.

LTG : )

Unrelated. Might be for lighting - I don't have a game to check.

Turn the game off. Check with a meter. Be sure they aren't adjusted so they are stuck closed and can't click.

LTG : )

Could be. Being I don't have a game to check, I don't know for sure.

LTG : )

To adjust a switch that hasn't been hit ?

LTG : )