You're currently viewing posts by Pinsider shaneus.
Click here to go back to viewing the entire thread.
Quoted from herg:It also gets rid of the clicking relay, which could be good or bad depending on your preference. Finally, it could be used to replace a failed relay board and for a bit more cost than standard replacements, you'd get something that works well with LEDs that also be less prone to failure than a mechanical relay.
I would not be upset with this functionality! I'd most certainly be in to test, but I'm sure the shipping and cost once converted to Australian dollars would be quite the killer.
You're currently viewing posts by Pinsider shaneus.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/gi-ocd-for-system-11-prototype-built-feedback-requested?tu=shaneus and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.