My buddy just dropped off a pin to be shopped out. The first thing i notice is that half the GI is out. Yep, j6 is toasty. Do you think this is repairable or is it time for a new board?
You're currently viewing posts by Pinsider doublezo1.
Click here to go back to viewing the entire thread.
Vid1900. The trace ends where you see it on top of the screwdriver blade. There is nothing on the oppisite side. I can only get a buzz from my MM when i touch the piece sticking up so basically a pin will not touch the trace when its in the hole..... im entering uncharted territory with my board repair skills.
Ok... looks like ill need to do my first jumper wire. Any helpful tips would be great. Or pics of said repair would be awsome! Thanks!
Ok... 18-20 guage wire. Circled in red are the connections that buzz with the MM. Im thinking of running the jumper wire as shown. Does this look like a good place to do the jump? Ive cracked open a few pops so it will have to wait until sunday afternoon, just plannin ahead i guess..
Sweet success!!! All gi works. Thanks for the help, im going to need some more. Im having another issue. When i start up the pin it doesnt boot. It makes the all good tone then does nothing. I press the advance button and get it into diagnose mode then it acts normal, plays etc. Turn it off and the same thing happens again. Hopefully i make sense.Thoughts???
You're currently viewing posts by Pinsider doublezo1.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/gi-connector-is-crispy?tu=doublezo1 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.