Just got done making the trophies for my Ghostbusters premium launch party setup for June. (registration currently full) These were a PIA to make, but I think they turned out pretty good. Had to do 2 separate castings. Similar to the way I make our league trophies. both are black light sensitive. I have 2 tournaments going, so trophies are for top 3 of both. Cut red vinyl for the NO symbol. Tried using paint and just could not get it even or mask it off effectively. Can or by hand. Even after 4 layers by hand, it was still patchy when light illuminates it. Hand cut vinyl was the best route but very time consuming. All black graphics were done with waterslides.

GB_trophies_008_(resized).jpg
GB_trophies_005_(resized).jpg
GB_trophies_002_(resized).jpg

btw, the soda can is just for size comparison.

I mean the offical one is nice, and it's great Stern sends those out. But I like to do something special for events I run. Plus I like more than 1 trophy so more people get a chance to take some hardware home.

makes me want to do more tournaments somehow relating to ghostbusters, just so I can get more use out of the molds.

yea, i hope not as well. I may have to push the date back. I don't think I know anyone that bought an LE. they either bought pros or premiums. A lot of us around here didn't like the green rails or the cabinet art for the LE.