Thread is now 45 pages long and I am sure this question has already been answered, but I
dare to ask in any case. The volume on my pin is now at 1 and the music is -20 and speech -10.
The audio is still quite loud and if I turn it up a notch to 2 or 3, it get much louder than to what
I have used to: usually the changes have been small and incremental with every notch, but here
the audio just gets quite much louder with every notch.

Is the pin supposed to be this loud, or is there some setting that I should use to make the pin
a bit quieter?

Adjusted music and speech to 0. Main volume is adjusted to 1...

I installed the airball prevention plastic from PU in the beginning of the left ramp, but now, if the
speed of the ball is slow and it comes back down the ramp with slow speed, it sometimes gets
stuck to the protector like in the picture. I tried putting washers under the protector and nuts to lift the
protector, but it did not help. I also loosened the nuts and it helped, but then the whole nut with
washer came off during gameplay. Any tips on how to rectify this? Thanks!

GB_stuck_ball (resized).JPG

I have a problem with the storage. It seems that many times the pin loses the ball and goes into ball search, when the ball falls into the storage. I read from this thread that there is some electrical tape fix that people have applied to slow the ball down. Could someone provide a pic, so one would know better where to apply the tape? Could dropdead foam be used?

My slimer's butt is also hanging too low, but even though I removed the set screw, it seems that it is next to impossible to get Slimer mech's rod moving. There might be some old glue etc. there saying do not remove the rod Any best practices on how to do it - using a hammer might not be the best option?

EDIT: Got it to move with some brute-force tactics

I ordered them and as I already had set the outlanes to minimum width, the ball got stuck between the outlane post and those rubbers. I would need to move the outlane posts back to maximum width in order to use the Yoyokopter rubbers, but I think moving the outlane post on the right side will be problematic. Previous owner had done that and when moving the post, had also chipped a piece of the clearcoat apparently. I am so not looking forward to that...

My 64 GB Sandisk does not work either (formatted into Fat32). I have tried 2 sticks now, so better to keep checking what other brand sticks I have.

EDIT: Finally it worked! Kingston 128 GB DataTraveler 100 formatted into FAT32 FTW!