Far Hills, NJ
Quoted from paul_8788:I haven't gotten a two ball feed on my GB even once, so doubtful it is a code issue, could be a trough opto issue.
I have the same issue. Very Random. Did turning down the power eventually work?
(Topic ID: 158288)
Linked Games
Ghostbusters (LE)
Stern, 2016-
Ghostbusters (Premium)
Stern, 2016
-
Ghostbusters (Pro)
Stern, 2016
-
Star Trek (Pro)
Stern, 2013
Topic Gallery
You're currently viewing posts by Pinsider cantbfrank.
Click here to go back to viewing the entire thread.
I am have a problem with my GBLE when I plunge the ball, even though the top left gate is open, the ball will hit it preventing the ball from going dow the left orbit.
Anyone see this issue and/or have a solution to fix it?
5 months later
Ok here are my current issues. Tried to go through this forum to see if they were addressed, but the forum is so large, I can't seem to find anything, even with the index.
1. Airballs on the left ramp - I installed the airball protector, worked for a while, but the protector now seems to sag in the middle preventing a lot of shots from going up the ramp. Suggestions?
2. When plunging, the ball rolls over the right orbit switch. If you have selected who "bought the dog" mode, the mode activates. If you selected another mode, modes shots are deactivated when the ball rolls over the right orbit switch. It seems the software does not realize this was a plunge shot.
3. Plunge shot going around Stay Puff, does not make it through the Left orbit gate. I see a lot of owners have this issue, but I have not seem any real correction.
Any help would greatly be appreciated.
Quoted from golfingdad1:This is very frustrating.
This is a problem with the shooter lane switch not registering.
Check switch under pf make sure the 1/8th in. Screws are not loose and it is tight and as high as it can be. Also if you have cliffys in the shooter lane it could cause th ball to sit higher up and not register that switch. Maybe a little bend of the switch arm if needed after checking under the pf.
Thanks good idea.
So I was trying to determine why the left scoop is going Sdtm. I think I have figure it out. It looks like the Coil plunger is a little off to the right of the hole where the ball sits. The coil plunger looks like it would hit to the right hand side of the ball which would cause it to angle left or towards the left flipper. The bracket that holds the ball seems to have been welded a little off from the main bracket. Whoever built the welding fixture needs some retraining.
Anyway, not sure what smart person can come up with to fix this issue.
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider cantbfrank.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
