Following
You're currently viewing posts by Pinsider Stones.
Click here to go back to viewing the entire thread.
Trying to wade thru thread.....the first few pages are just painful.....lol
Need some help here. The super jack pot doesnt always register on the left ramp. The switch tests find in test mode. Can a person bend the switch a bit?
Ok......the switch on the left ramp is still an issue registering shots. I have bent the switch so it does register shots.....but not consistently.
It either:
A) works 75% of the time....then, over time registers less and less
B) bend too much and stops the ball from going down the subway.
Anyone just replace the switch?
This is for the premiun
It seems like quite a few people have had to replace the switch. I'm a rookie at some of this.........it doesn't like I need to solder? looks like the switch is just held by 2 screws?
Also, double checking...is this the switch I need from Marco?
http://www.marcospecialties.com/pinball-parts/180-5199-00 (I know I need to order the new part number)
Quoted from GorillaBiscuits:My LE does the same thing, although it starts off working 100 percent and then eventually goes to around 75. Ball has only gotten stuck from a really lucky weak hit after bending, presume this is why the ramp is so steep to prevent?
Next time it happens I’m just replacing the little jerk
If I nail a straight shot up the ramp, the ball goes flying through there....and doesn't register...if the ball halfass goes thru...I'm good...and it registers. Not a great spot where they put the switch...but I just wonder if the switch itself is just junk.....
Quoted from PinMonk:Definitely need to solder. If you don't have a soldering station, let me recommend:
amazon.com link »
Page 45 of the manual says that switch is 180-5209-00.
Thanks man. Ordered the switch today
You're currently viewing posts by Pinsider Stones.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/ghostbuster-issue-thread?tu=Stones and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.