How do I disable the Scoleri brothers as some have done here?
You're currently viewing posts by Pinsider Mobsync.
Click here to go back to viewing the entire thread.
Quoted from Shenanigander:Need to place an order for Marco for pick up at allentown (today is deadline)
I cant seem to find part numbers for:
Scoleri drop springs
Auto launch spring
Anyone know these off hand? I see the pinball life link for scoleri springs but need to order from Marco. Thanks!
I'd like to know the auto launch spring part number at Marco as well. Anyone?
Quoted from gweempose:Easy. Just go into the menu and disable both drop targets.
Thanks!
After replacing my flippers I get "locating balls" and the trough test shows no balls but all six are in. Any suggestions?
I have reseated any plugs I removed to get to underneath the flippers when installing. Baffled and infuriated.
Help!
Quoted from northvibe:start with visual check of trough switches and make sure they are not missing a wire that fell off
then go to switch test and see if the switch registers.
Trace back switch(es) that do not register to where they go. I don't think a manual or schematic is out so hard to show a switch matrix etc, but sounds like it may be all related to one place if all trough switches do not see a ball
Stern sent me new trough circuit boards which I have replaced but I still get the same error, Missing 6 Pinballs. The trough test still reads empty. Would someone please take the same pics I have below and post to see if there are any differeces?
1. board on trough
2 - 4 board underneath left flipper area
5. board on left of cabinet
thank you!
20170528_131020_resized (resized).jpg
20170528_131033_resized (resized).jpg
20170528_131026_resized (resized).jpg
20170528_131053_resized (resized).jpg
20170528_131042_resized (resized).jpg
You're currently viewing posts by Pinsider Mobsync.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/ghostbuster-issue-thread?tu=Mobsync and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.