Test the transistor on the driver board that runs that coil,Turn game off set meter to continuity place black probe on ground strap(in the backbox) and red probe on that transistor tab.If your meter beeps that transistor is shorted and needs to be replaced.If your meter does not beep then that transistor is fine.

Which/What fuse is the one thats blowing on the driver board?

sorry for the delay im downloading manual....running slow

Did you test the coil with a meter?
Power off the game,Set your meter to ohms
Place one probe in left hole(above coil tab) on coil
Place other probe in right hole(above coil tab) on coil
meter should read 2ohms or higher

Do you have the manual?if you do check and see where the location of the predriver is on the driver board.Its in the same area above the transistors,I was trying to download the manual and locate it for you but its just way too slow

To test predriver set meter in diode setting.Power off the game
place black probe (keep it there on center leg) of predriver-theres 3 legs
place red probe on top leg-should get a reading,using same red probe measure
bottom leg-should get a reading.Try this on other predrivers they should all
measure/reading should be the same.

Its Q1 through Q9
They are all transistors it would be a good idea to test them all..

Now I know im getting OLD!!! Lol!!!

Q9 is transistor TIP-36C....If shorted will need to be replaced.