Getaway: High Speed II, The
Williams, 1992Hey guys, had a wire come off a connector on the Power Driver board (J109) and can't find in the schematics which pin this wire goes to. It's a Violet/Orange wire. (probably flipper/coil power)
If anyone could help me out, I sure would appreciate it.
thanks
Allen
What is your symptoms.
Violet/orange should be Sol. 3 Down Ramp J130-4 or there is a Violet/orange out of j107 which is a daisey change wire that runs the out hole, bot jet bumper, lt jet bumper, top jet bumper, High current driver on J1-6 Ball release and eject hole.
thanks guys, we figured it was a daisey-chain out of J107-2 ....
and some previous operator hooked it to 109.
thanks again
Allen
Just an FYI something you may want to look at. I know the WPC CPU board J207 is where the molex connector gets hooked to is parrelled directly to the above J209 which is empty and not used. So you may be able to use j109, if J109 is vacant and located above the J107. I don't have a game to look at but is worth bringing up. Test for continuity between J107-2 and J109-2 if the J109 "port" for lack of a better word, is not being used. I am curious about that. Anyone here know more about that?
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/getaway-help and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Jeffersonville, IN
Swifterbant