My diverter stopped working.
I dont know exactly how to use a multimeter, so maybe I’m doing something very wrong.
When I run the solenoid test for ball eject (which works fine) and measure dc between j107-2 and j127-1, I get intermittent blips of a couple of volts. When I run the same to j127-3 for the diverter low, I get a continuous reading per picture below.. so I try the same thing with a dmm that I just purchased, and I dint get any reading but smoke starts coming off the j127-3 pin. I try same test on j127-3 with analog meter without running solenoid test (machine is just on) and I get the same very high reading. I pull the f104 fuse and then I get no voltage reading between j107-2 and j127-3.
Any ideas what’s going on? Also any tips for what I’m doing wrong with my mm’s?
1DB18E97-234D-4394-B59D-BA598E7C10A8 (resized).jpeg