My Getaway is missing both 'bits' in the area pictured and I'm not quite sure which replacement posts to purchase from Marcos - can anyone help me out with a part number? Thank you!
You're currently viewing posts by Pinsider thebred.
Click here to go back to viewing the entire thread.
My Getaway is missing both 'bits' in the area pictured and I'm not quite sure which replacement posts to purchase from Marcos - can anyone help me out with a part number? Thank you!
Quoted from Mr_Tantrum:Are those 02-4020 Support Posts (see page 2-36 of the Getaway manual which shows qty 2 of these on the board)? If so, a few searches on common sites seem like they are hard to find.
I was hoping they might be 02-4425-1 - which might be possible. The manual says there are only two of those.
Quoted from Mr_Tantrum:I don't think they are 02-4425-1 (at least in my opinion). While I am not at home to look at my pin, from all the pics I've seen, these appear to be bored threaded posts with a screw/bolt at top, a washer at bottom, and most likely a screw/bolt/washer on the underside. If I remember, I will take a look when I get home tonight to confirm (or maybe someone else can look at theirs before then?).
Thanks, that would be a huge help. Didn't realize it would be this tough locating replacements. haha.
Quoted from Manimal:Went back and looked, and the spacer is indeed 1/2" in height. Find the smallest diameter aluminum spacer they have, and make sure it is unthreaded. Most hardware stores have these nut/bolt assortment trays in their store somewhere. Then buy a stainless screw and it will look and work just fine. If you can't find one, let me know....I will be happy to go to the hardware store on my way home and pick two spacers and screws up for you. I would rather do this so you know it will work, rather than guessing on ordering something and having to pay shipping, etc. We can do it here for less than 2 bucks, including postage.
HUGE Help, I'm going to run to the hardware store in the morning. Much easier than I anticipated.
You're currently viewing posts by Pinsider thebred.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/getaway-club-dispatch-run-a-make-on-license-plate-kingpin?tu=thebred and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.