Will be a member very soon!
Isn't this just a well-engineered, well packaged hack?
Quoted from NPO:
I would say no. Are there any wires hanging low keeping the ball from making the shot?
I've seen that problem before, but never diagnosed it. There are at least two rollover switches through there - perhaps the switches are sticking and the ball gets hung up on weaker shots?
Quoted from indypinhead:
I'm finally starting to put my Getaway back together.
I noticed in this thread, that the wiring harness for the supercharger ramp is routed above/behind the PF backboard....
My wiring harness is routed thru the hole in the upper left corner of the PF. Which was is correct?
My wiring harness goes through that hole too - it fits, but the Molex connector is a tight fit for sure.
Great to see you're enjoying Pinside! Did you know Pinside is able to run thanks to donations from our visitors? Please donate to Pinside, support the site and get anext to your username to show for it! Donate to Pinside