To someone who has a working Xeno mechanism with I/O boards stamped 0.94 (obviously they've been updated--but original boards) how/where is your 12 volt yellow/black power cable plugged in (instructions from Helmut show yellow pin 1, black pin 2, but my connector is oriented to plug in the opposite way). Also, where is your 4 prong connector plugged into (it's the 3 blue wires and nothing pinned for the fourth spot). Again, instructions say to plug it into a spot labeled "Xeno modes" but this I/O board has no such label. There isn't a lot of extra wire length to these connectors so I'd imagine I have them correct, but I'm once again starting from step one and trying to figure this out.
Edit: still working my way through the steps and "step 7" shows the 7-way rainbow colored connector plugged in. I see that, but also in the picture from Helmut, a blue/nothing/black connector is nearby. I don't have such a thing, and the empty plug where it goes is labeled "SW8". I do, however, have an orange/nothing/black connector two spots away (in the picture, it is the farthest left of the row of connectors) from where that should go, and that is labeled "SW6". Hmm.
Step7 (2) (resized).jpg