Did it both ways one just the mpu and one all in one board. If all other boards are good and brought up to snuff then just go mpu only if you need more boards just go all in one . vid1900 is right you can sell the other boards. Would love to do the board swap on black hole and add 7 digit scoring but it works fine so it stays stock.

Got all my parts needed for my#genie form Steve at the pinball resource. Flipper parts, new lamp spinner,drop targets,rubber kit book etc

Just wanted to give a heads up to fellow Genie owners Pinball resource now sells new playfeild plastics for you who need new ones or just need to hand over more of your hard earned money to Steve. http://pbresource.com/plastic/gtb-c19183+.jpg Was on the pbr page looking for something else and have found yet something else to add to my list.

Both lower right and upper right flippers.
IMAG7910 (resized).jpgIMAG7911 (resized).jpgIMAG7914 (resized).jpgIMAG7912 (resized).jpgIMAG7913 (resized).jpgIMAG7915 (resized).jpgIMAG7916 (resized).jpg

Hope this helps you.

Yes I did kick the flippers up a notch with the orange coils. The yellow ones gtb a-17875 even after rebuild flippers with full kit from Steve Young/pinball resource they just weren't flipping good. Yes I did shatter a drop target in the middle bank but needed to change the yellow star targets anyway they looked bad the sharpie stars were sad looking.

Mine had the same issue when i got it.