Does anyone have a clear picture of connector J4 on the interconnect board? I’m troubleshooting a Dr. dude for a friend and someone prior had wires wrong. Mr. big was being triggered by the pop bumpers and other coils. That turned out to be his coil wire was connected to connector J 12 which is for the flashers. Every time a flasher went off Mr. big would jump around and sometimes lock on. I also corrected the heart and gift of gab flashers because they were
swapped in the wrong spot.
It has been hard to find accurate wiring diagrams for this game and it is odd that I have two brown blue wires.
The game also has the WPC P-6 Roms installed Which very well could be the cause of the issue. I burned the two correct ROMs for the system 11c. U26 and U27 But the game didn’t boot when I installed them. Might be because I used 512K chips instead of 256K. I didn’t want to erase and burn over the installed rum since the game boots up and plays just with that odd behavior. I don’t want to be stuck falling back with an unbeatable game so I may have to see if any friends have the correct size chips.
In the meantime I would like to be sure to get the wiring to that connector correct.
499B41F4-75E4-4FA3-9307-7409D95E656E (resized).jpegC8087C78-1FA9-4761-8786-416D95163434 (resized).jpeg