Just brought home a GB Premium. Get it set up and expect to start playing a few games HOWEVER...
When I went into the menu to check settings first thing I see is technician alert. So I think oh here we go...

F14C5AEA-9AA4-49FB-8571-636FF251B6BC (resized).jpeg

Says it’s the EOS on the right flipper so I go into the test mode and manually move the flipper and get no response but when I did it with the left flipper it would recognize when active.

So I prop up the playfield and start to look around.
First I find this little plastic piece in the cab.
I see where it was attached to the flipper mech.

11441FBD-902B-495D-878A-D8439DA0FFD5 (resized).jpeg

440251C8-7E16-478B-9629-1D79BA218B40 (resized).jpeg

I keep putting the switch back in service and the game keeps taking it out.

D345C6A0-6649-49D1-8461-F14F00434189 (resized).jpeg

I trace the wires back and I see it’s connected to this board under the apron and it looks like these wires were marked...

04195A0F-B128-4F39-A31F-7915BCA7421D (resized).jpeg

Any thoughts?

Yes I’ll be ordering a replacement link however the switch is still not responding to manual activation and is not mimicking the left EOS when I manually activate that one.

I put the switch back in service and then break and make contact but the switch doesn’t activate. When I do the same to the left the switch test shows the left EOS response on the DMD. It’s like this right switch is unplugged or something.

Ok I don’t think I’m explaining this properly.
I’m not concerned about the piece that broke. That’s a simple fix. And I understand that piece separates the contacts of the EOS.

What I don’t understand is when I put the switch back in service and manually separate the contacts of the switch and then let them return, why doesn’t the switch register?

If I do the same thing on the left side the left EOS registers in the test.

Replacing the mechanical piece seems to be half of the fix but why wouldn’t the switch activate now when I’m manually working it with my finger?

I get continuity on the closed switch

8D16CD59-6D17-44F4-9968-2C20C19F5D75 (resized).jpeg

Because it’s a normally closed switch a put a piece of paper in between the contacts and I get continuity from the green and gray wire. 5th pin from the right on CN10. However I’m not sure where the green and black runs to. There appears to be 3 green and black wires on this board but I can’t tell if they’re the same wire coming from different sources.

16C5BFE2-C0A2-4749-97BA-4E244638943A (resized).jpeg

I need to re-evaluate life....
So I kept tracing and look what I found over on the left EOS

F993D10A-4D6D-4735-86AD-B6A6E33CE91D (resized).jpeg

You beat me to the punch!
Thanks man!!!