Anyone have scans of the Sharpshooter spin target and drop targets? If not I may try to scan and clean the images.

Cool, thanks.

Thanks Spooky, put me down for a set as well.

Does anyone have a full or partial scan of a Sharpshooter playfield? Doing repairs and was hoping to speed this ups (rather than me trying to guess and draw in the missing parts).

What extras do you want to turn off? You can turn a lot of the extra ball stuff off in the menu/dip switches.

Ok. S29 to "on" awards replays instead of extra balls. I'll check and see if there are others. I also have mine set at 6 1/2 degrees, plays very fast.

What my Sharpshooter uses is 21-50003B.

I'm jelly....

Ok, here we go. Looking at the print (not home right now). MPU J5 - Black is Strobe 3 on pin 3. Gray/Yellow is Line 2 on pin 15. LDU, looks like you are talking about J10. Solid Blue is Loop 1 on pin 14, Yellow/Blue is "Same Player" on pin 1. Is that what you were looking for?

Pinball Life can fix you up with what you need. Just send him an email.
I think I used unmarked Williams bats.

pasted_image (resized).png

Yes, get your voltages right to start with (That bridge). Do you have a service manual?

Rubbers
https://www.marcospecialties.com/pinball-parts/RK1638-1

I also didn't see if you tested the ac voltage at the bridge. Did you have ~28 vac across the ac input to the bridge?

Ok, the "odd" tab is "+" and the tab diagonal from it is is "-". The negatives of the bridges are all the same. you want to check the opposite tabs from those. Looks like Green/Brown and whatever the color is diagonally opposite.
Like this:

- (+) | (ac)

| (ac) | (-)

Good deal, I was going to mention I thought that loop was the test point but it's been a while since I was into mine. Parts are cheap, the experience invaluable.

If I can remember, which could be a stretch, I had the same issue. Sharpshooter was my first SS pin. When I plugged the head in, I reversed 2 connectors that are the same or very close in color. After repairing almost every board in the machine I think I had the same issues. I think I had to replace 2 of the U2 I.C.'s. If I remember correctly, these are hard to come by and think I got some fakes off of eBay and did not work. Bought some used ones and they worked.

The bonus hole should work regardless of the rollovers. Give the switch a good cleaning a crisp 100 dollar bill or an eraser (careful not to bend the switch). Make sure to test the switches with a ball (assume you are doing this anyhow). I have trouble with the rollovers not always registering so I may add caps to those switches some point.

I had issues with my dip switches. I got replacements but never changed them. I think they were starting to deteriorate if I remember correctly. Have you replaced all the crappy green capacitors yet? Not sure if that would cause you your problems like that though. Maybe intermittent issues with the dip.