Install:
Machine off for whole process and balls removed:
Remove flashers and lay to the side.
Remove the plastic ramps on both sides including the threaded studs beneath them shown with arrows.
Use included lock nut and install on the exposed screw head on right side as seen in picture.
Remove both sling rubbers and plastics. Remove the screw and plastic post on both slings.
Remove plastic under groot head and note the stacking of plastic spacers on rear post. Remove that post, spacers and screw and lay the spacers out in the order removed.
Remove the left rear plastic behind rocket and the rear post plastic and screw.
Remove the plastic to plastic ramp adapter. Take the new adapter and sandwich them together and place under the remaining ramo holes. Start the two screws carefully and then tighten into place.
Raise playfield:
Install the new 3 inch screws into the now empty inserts. Tighten them all the way to the insert and snug into place. You will now have 4 threaded studs above playfield. 2 at front slings, 1 to the right of groot head and 1 behind rocket.
Lower playfield:
Install the post plastics over the 2 sling studs. Put a washer over the post plastic and then install and tighten regular nuts.
Do the same thing to the stud behind rocket. Then put the plastic post (by groots head) and put the spacers back over stud in the same order removed.
Once all those are tight reinstall the covering plastics and rubber slings. Place a washer on top of the plastics and then install locking nuts. If the stud spins you might need to tighten the screw below playfield a little more. You can also use a screw driver holding the screw under playfield and tighten the nut with your other hand.
Rail install:
The studs by rocket and groot came with 5 washers each. Lay the rails into place and determine the spacing for the stud. Start with 1 or 2 over the studs and see effect of tension. Less washers lower the rail and ramp more raise it.
*********************************
(This was to address video complaint of vibration so its adjustable)
**********************************
All mounting points will need atleast one washer in place. Start all the nuts and screw but dont tighten. Center the ball drops and tighten into place. Then tighten remaining nuts.
Flashers:
There are 4 nuts on the flasher studs. The lower two can be adjusted to level flashers. Install the flasher led then the dome plastics. Tighten the lock washers on flashers and keep the square led flasher centered while tightening.