Quoted from wxforecaster:I'm really digging the lockdown bar idea since I hadn't touched it until I had to source the GI burned connector issue to begin with. It is bare metal and it's possible it's touching the coin door lamps. I'll wrap it in tape and see what happens. None of the bulb sockets should have seen any change. Very frustrating indeed. I need a 100 pack of 5A 250V SB fuses at this point
You need one of these...
http://www.greatplainselectronics.com/Category-56.asp
Solder a fuse across it.
The coin door GI comes from J119 on the driver board. You could simple remove it to test.
--
Chris Hibler - CARGPB #31
http://www.Team-EM.com
http://webpages.charter.net/chibler/Pinball/index.htm
http://www.PinWiki.com - The new place for pinball repair info