curious to try these in my FH for the inserts as they state "This bulb will reduce flickering due to minor voltage irregularities.
It wont stop controlled fading from a game, that causes flickering in attract mode."

http://www.cometpinball.com/product-p/1-flux.htm

If these dont do it, then I may go the OCD route too.

Care to share your logic on removing the wiring (switches, coils, lamps, etc) from the bottom side?

Did you work your way around doing everything? (seems like it follows a logical path)

or did you just pick one at a time (start with switches? coils? etc)

This is where I am at with mine and I am finding this part a bit overwhelming for a first timer.

Curious about this as well, I did buy some Mylar sheets from Kruzman (When i bought his install kit) so I am planning to go ahead and mylar the pops and ball drops. But curious what others did.