Hey All- looking for some help/suggestions with a couple LER LED Strip Mods (Ordered from Mezel Mods) I'm doing.
1) Trough LED Strip Light
-The mod has you attach the strip to the trough metal and replace a GI Bulb with a new one provided that is attached to the LED Strip. I have two questions on this:
a) The bulb provided from tip to base is much longer than the normal LED lights (see picture below), so when I replace the GI bulb I can't get the holder to be flush with the playfield again to screw it back in place. Forcing it in further would make it stick up through the playfield WAY farther than intended, looking weird (if I can even squeeze the wires through the hole) Any solutions to this?
b) Which GI Light would be best to utilize at this location?
LER LED Mod Light (resized).jpg
2) Backboard LED Strip Lighting
- The mod has you adhere the strip at the backboard location, feed the wire behind the playfield and replace a GYI Bulb with a new one provided that is attached to the LED Strip. I have two questions on this one as well:
a) It's not 100% clear, but I believe the intended location for the LED Strip is underneath the bottom plastice piece which serves as the Playfield glass guard (see picture below), and the wire is to be fed behind the back left of the playfield. Am I correct here? If so, this seems like it would create a very exposed/visible wire? Any way to make this less visible?
b) Which GI Light would be best to utilize at this location?
Backboard Light Mod (resized).jpg
3) I ordered the under cabinet/back board lighting kit that's supposed to be specific to and integrate with the Funhouse lights. I haven't received it yet, but if anyone has any experience to offer before hand, happy to hear them.
Thank you for any help.