I'll probably be interested in the F-14 ramp, once it's done.
Quoted from dung:
So, knowing a machinist who is into pins, sure. Problem is you need the geometry. I originally looked to make a 3d model to print and then cover in bondo, but getting accurate measurements proved too much.
That would be me...
If I had the 3-d geometry, I could give it a try. It would be costly for the material if you were to go with Delrin, (Acetal).
Great to see you're enjoying Pinside! Did you know Pinside is able to run thanks to donations from our visitors? Please donate to Pinside, support the site and get anext to your username to show for it! Donate to Pinside