Throwaway post. Unable to attach pics to direct message on android. Made topic to continue discussion. Will delete topic when finished.

15925204956456189014050499296470 (resized).jpg

20200618_184210 (resized).jpg

20200618_184156 (resized).jpg

20200618_184200 (resized).jpg

20200618_184215 (resized).jpg

20200618_184223 (resized).jpg

Center to center hole on bracket appears to be 2 inches on the money

1592520656660732778916509745029 (resized).jpg

Exact clearance between bottom of bracket post and top of diverter post is 7/16 inch.

Anything fitting between them would need to be smaller than this.

20200618_185612 (resized).jpg

Is this the measurement you are going for?

If so, there is between 5/16 to 3/8 inch between center hole on bracket and edge of diverter mech plate.

20200618_185420 (resized).jpg

20200618_185538 (resized).jpg

While on the other side it is about 3/8 to 7/16 between center hole and side of pf.

15925213238543042784481969165107 (resized).jpg

Shots of the mech going to top of PD, in case this affects your design in any way.

Will definitely need to come from underside of PD, because that diverter mech metal bracket will be a PITA, lol

1592521459356896290578426342695 (resized).jpg

15925215197735712766263924806099 (resized).jpg

Brackets are identical, only difference is in the way they face on the pf.

15925218101201469228465579312848 (resized).jpg