I ended up removing my Mantis protectors. With those installed, the switches only register intermittently. The right side was a lot more difficult to install than the left.. Does anyone have any tips on installation?

I'd rather leave them off if there's no good way to get them on without the machine playing poorly..

My direct hits were having the most issues. I tried adjusting the leaf with little success.

I thought I remember someone posting that they routed that hole?

That's what I have on the right, so I think that does cause a bit of conflict. I may remove it, since the mantis would do plenty to avoid any damage to that ramp. It's not exactly easy to get to, so I think it will stay in place until the next shop.

Otherwise, I had been doing everything regarding put the screws in new wood. I probably could have spent more patience adjusting the switches.

Pulling the upper isn't horribly difficult, but I just got done going over this game a few weeks ago. I don't feel like tearing it back down. I'll get some replacement decals for under the ramps, and maybe a new boulder set. After I get those, I'll take it down and have a better look at what needs to be done to get these installed.

I like the way they look... I have green LED's behind those spots (to glow that area green), but I don't like looking at the bulbs...