Pinballs are like puppies. The longer I have this game, the more I want to keep it and restore it myself. I think this will go off sale very soon.

This game needs to be shopped. It is 100% working (except for diverter discussed below-replaced 11/24). The cabinet is really nice except for the scratch and the drill hole noted below. The playfield is nice except for typical wear around the 3 holes, I did notice small holes between the flippers where the left metal guide would go (thanks Darin for pointing that out).
* The red pin cabs DO NOT come with the game. I just added them for protection.
* Rubbers need to be replaced.
* Lights need to be replaced or switched to LEDs.
* All switches work.
* All coils work.
* Right front leg bracket replaced as well as all 8 bolts.
* Battery holder replaced with new-remote battery holder.
* As shown in the photos, the plunger (A-16636 $4.70 at Marco) needs to be replaced on the left back diverter. as of 11/24 the plunger has been replaced and this works 100%.
* The header plastic is broken as shown in the photos.
* The plastic below the left ramp above the assist hole is broken as shown in the photos.
* The right ramp is cracked and re-glued just above where the top and bottom section screw together as shown in the photos.
* The left side of the cabinet right below the soccer ball has a scratch in the black area which should be easily fixed as shown in the photos.
* The front cabinet has a hole near the "C" in "coin toss" where a lock was previously installed.
* The goalie needs a new rubbery backing since it has disintegrated in the area holding the screws to the switch.
* The free kick hole's finger sticks up after the ball is kicked out. The finger pivot point is greasy and dirty and needs to be cleaned. 11/24 I removed the assembly, removed the grease and it works perfectly.
* On the backglass art, on the dog's left hand with the ball, there is a small area that has been repaired previously. You can see in the new photo the area that has a slightly different color.
* The metal guide for the lower left hole below the magnet upper playfield is loose. When the ramp and upper playfield is removed, the two hex screws should be tightened.
* 11/24 I just reseated all the connectors on the MPU and driver board and the GI in the back area, including the yellow lights, is one.
* The bracket holding the top part of the ramp to the right side extension is missing as shown in the photos.

Local pickup in Purcellville.