This is a restorable project.

Have not booted it up yet, so it's as-is. All the displays and original boards are there. The MPU has a little battery damage, but it's fairly minor. I have a pascal MPU on-hand for $165 if you really want one along with the game (note this is just the stand-alone mpu--not the all-in-one board).

The front of cabinet had some sort of spill possibly combined with road salt, but the cabinet is intact, and there aren't too many signs of actual water damage to the cabinet. Metal parts are rusted in that area, though, including the lockbar, lockbar receiver, playfield hooks, apron, shooter gauge, shooter assembly, and the coin door is badly corroded and the coin door frame is missing a couple chunks from it. The rest of the game is rust free.

I will include a lockbar receiver, playfield hooks, spare apron, and shooter gauge.

I can dig out a replacement coin door for $65 if you really need one, but there are also a couple on ebay right now as well.

The playfield is in nice shape overall, and inserts are completely level, unlike on most games. However, there is some old water damage under the apron, but it's not visible unless you look under the apron. Just glue and flatten the area, and it should be fine.

There are broken plastics, but new sets are available from PBR for under $100. A yellow drop target is broken. The metal post near the "10 or 100 when lit" target on the left side is missing and was replaced with a small playfield mech screw, but didn't cause any damage--you should just be able to replace it with the proper post.

There are some dings & scratches in the cab, but nice colors--the reds haven't faded too much. The backglass is nice and has good color, but has a few tiny flakes coming off, so it will need to be sealed.

The small wood block where the power switch is mounted and the piece of sheet metal on the bottom of the cab may need to be replaced.

A set of rusty legs is included, but a good soaking in evaporust and some polishing should make them look decent again.

Missing the 4 lower (#8 or #10?) wood screws to fasten the backbox vents to the cab body.

I have a new game coming in, so I need to move this one to clear some space. Sorry, no trades. More photos to be added soon.