The good:
Working 100%, no credit dot
Very nice playfield, only minor fish wear mentioned below
LED'd
Stadium lights and trough light with RF remote, magnet mounts, and quick disconnects
Dedicated power supply for stadium lights professionally wired into the power harness. Plenty of amperage left for other 12V mods!
Completely rebuilt Red and Ted's heads with a bunch of new parts
Cleaned and waxed everything while the ramps and heads were out
Pinbits auto-eddy board on Ted
I laser cut some custom PETG protectors for the lower plastics, blast hole, and Ted's dozer
Shaker motor is nice and strong!
Ramps and plastics are perfect
Comes with manual and a bunch of extra plastics, custom and original instruction cards
Cabinet has a few minor bumps and bruises to be expected but overall is in nice shape, same with the original blue legs
I replaced a few high traffic rubbers with silicone ones, the rest weren't put on by me but look very new
Scoop area and inlane drops are mylared
Adjusted all the switches
New balls

I'm an electrical engineer and always go over all the boards:
NVRAM
Rebuilt the 12V and 5V sections
Replaced connectors/headers
Replaced a bunch of capacitors
Touched up cold solder points
Running latest ROM, patched for LED's

The bad:
No fish wear, just some black missing around the white GI insert next to it. Somebody else laid down a piece of mylar to protect it.
Somebody else did a pretty decent job patching the lockbar holes and touching it up
The apron has some flaking paint in the middle, which is very common on this title for some reason
There's a small (cigarette?) burn at the extruded plastic where the top of the glass goes into
There's a single scratch on the translite, otherwise clean and perfect


I'm in the NW side of Chicago, 10 minutes off of I-90 (Addison exit)
I'll always hear a trade offer (especially for projects)