Deadpool (Limited Edition)
Stern, 2018You're currently viewing posts by Pinsider dno.
Click here to go back to viewing the entire thread.
Quoted from coop:However, after the rebuild, this same left flipper when hit by a ball while it was in the up position would not be able to take the weight of the ball's inertia so it would bend down slightly and then spring back.
When the flipper “crashes” like described, the EOS switch isn’t functioning right.
I would start there.
Quoted from Pin_Guy:Best guess ... you simply don't have the proper vertical spacing set on the flipper and its binding against the bushing...or worse the playfield. The flipper should have a vertical movement of roughly 1-2mm when moved up and down; if you dont have this spacing simply loosen the hex screw and pull the flipper up a little bit to achieve this spacing, then tighten it back down.
This is also good advice for sticking.
Also of note, the EOS not working could be a broken wire off of the other flipper, they chain the black wire from one to the other.
You're currently viewing posts by Pinsider dno.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/flipper-get-stuck-in-the-upright-position-on-modern-stern?tu=dno and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Highlands Ranch, CO