Started this problem in the FG thread, but thought I’d open it up to everyone since it might get lost there.
I replaced coil sleeves on the bottom flippers, and after doing so the rhs flipper/s causes f4 to blow. Sometimes on first flip, sometimes after 4-5 flips.
Have swapped a new/known good coil in and swapped a new/known good power supply board in and still happening. Can’t see any obvious shorts, but there must be.
Where should I be looking??? If it’s only the right flipper causing it do I just follow the high voltage wires to/from there? Will it only be something on that circuit (not sure if that’s the right word)? So only the rhs lower and upper flipper causing it?
303B0F3E-A5F8-4C19-9239-683B520FF7E8 (resized).jpeg