KS
Those wires explain a lot. You need to get some new Molex connectors from Pinballlife and put new connectors on the end of those wires. You will be chasing a lot of goblins so long as you have connections like that.
(Topic ID: 194905)
Linked Games
Fish Tales
Williams, 1992
Topic Gallery
You're currently viewing posts by Pinsider Manimal.
Click here to go back to viewing the entire thread.
Quoted from shacklersrevenge:Those wires are all for his general illumination and are not the cause of his resets.
A scrambled dmd, I would suspect ribbon cables and reset all the ribbons. It's also possible your caps and bridges have seen better days.
How do the connectors look on the far right top side of the driver?
Even GI problems can cause voltage fluctuations....I was thinking about the resets and not the DMD. I do agree that could be a ribbon cable..
Beyond that though, take a look at that bottom left fuse.....do I see a wire soldered to the outside? That needs to go as well...........
Given the looks of that board and the fact you are saying someone glued in a drop target and removed the mech.....I am betting you are going to need a good service guy to help you. I am betting there are other hacks we haven't seen yet. Do you have any local pinball service? (Sorry but I don't know what is available in Argentina)
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider Manimal.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
