Quoted from cosmokramer:...can I fill these another way
A welder.
(Topic ID: 150874)
Linked Games
Pinbot
Williams, 1986
Topic Gallery
You're currently viewing posts by Pinsider grumpy.
Click here to go back to viewing the entire thread.
Quoted from cosmokramer:this is what Im getting....
Does it have a argon/Co2 tank and regulator?
Did you get the MIG welder? If you take a copper penny and place it over the hole. Then weld the hole shut. The penny will keep your weld from just falling thru and act as a heat sink to help from melting a bigger hole. Since the penny is copper (old penny) it wont stick to the door or the weld. Also you will only need to smooth out one side.
1 week later
Quoted from cosmokramer:it has this little board tied in to the games played meter
Just a 12 volt relay to pulse the counter. Why is it needed, I don't know. The CPU stores this kind of info already. Me I would remove it.
Promoted items from Pinside Marketplace and Pinside Shops!
Pulaski, PA
You're currently viewing posts by Pinsider grumpy.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
