I'm not sure what I'm looking at... Which wire is disconnected? One inside the switch?
You're currently viewing posts by Pinsider setzkor.
Click here to go back to viewing the entire thread.
Seconded... Likely to that contact your finger is next to. You'll probably see some solder left on it where it is supposed to go...
Not familiar with that particular switch...I would assume you can pick one on the back and the one in the middle on that side. But I also know what happens when you assume (ass out of you and me)... Especially with electricity. If you have a multimeter, measure resistance between two like that, then throw the switch and remeasure. If it goes from 0 ohms to infinite, solder away. If not try two more until you find the right pair.
To add...I'm assuming you have this kind of switch...
http://www.learningaboutelectronics.com/Articles/Double-pole-single-throw-switch-DPST
The trick is to find which pairs are together...front/middle, or front/front and middle/middle
You're currently viewing posts by Pinsider setzkor.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/firepower-wont-turn-on?tu=setzkor and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.