I had to physically tie the ground from my power board to the ground on my RD board and this problem went away. I just used a hunk of wire around the mounting screws on each board.
Jeff
You're currently viewing posts by Pinsider Grangeomatic.
Click here to go back to viewing the entire thread.
I had to physically tie the ground from my power board to the ground on my RD board and this problem went away. I just used a hunk of wire around the mounting screws on each board.
Jeff
I do not have a picture.
I just took a scrap piece of wire, stripped both ends, wrapped one end around a grounded mounting screw on the power supply board, and wrapped the other end around a mounting screw on the RD board.
Machine had been resetting rather regularly, and completely stopped after this.
A buddy had a similar problem, and this fixed it for him, too.
Good luck,
Jeff
You're currently viewing posts by Pinsider Grangeomatic.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/firepower-w-rottendog-board-flipper-reset?tu=Grangeomatic and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.