Hi Folks,
I have a Firepower with a Rdog power and MPU board.
Using l.e.d.s with the large warming resistor cut I have the following problems:
1) One blue hotdog light constantly on and does not flash when it should. Led flashers work correctly. This socket was replaced with a two prong instead of three prong with the tie. I just soldered the diode "in-line" and omitted the tie point as I didn't have one.
2) Some l.e.d.s are flickering slightly. Primarily the "R" and "E" but the "Shield" somewhat. The flickering was present
before the socket replacement.
Bad diode somewhere? I swear I checked them all three times!
Milton