Yay another one of these with all the usual suspects I see. Well I can't really give an accurate comparison since I haven't used a fast system and I haven't used mpf so I can't say it's better or worse than the tools I used. I have one complete fully functional game made from scratch powered by P-roc called deadpin and another made with the P3-roc that is just about in the testing phase. Connecting the boards is simple and fun. Really easy to be neat or should I say gives you the choice to be neat . My first machine was written in pyprocgame. I am not at all a software guy but I was able to write a set of rules pretty quickly. If a had a problem I just asked and got an answer pretty quickly on the forum. The community is strong that's for sure. Lots of smart. Capable builders and programmers ready to help.

its really hard to stay nice

I find it difficult to say good or bad about either board or software without Successfully using it. Really bothers me when people say stuff about something that they have never experienced. Even when they say anything without completing a game in general brings me annoyance

well you got me there Mark. lol. But you just annoyed me because you haven't completed a machine Mohahaha

Very Nice Print Lachied. I used to hate printers. Till i got one and it sure does help on some stuff
But it will never replace me working with clay. I enjoy it too much

That would work pretty well i think. Ive been using it to make stamps of repeating patterns then go over it again to bring detail and make it look random. Total time saver. Looking forward to seeing your pin done