Hi everyone,

I recently put my Baywatch on route after shopping it out. I'm having a problem with the 7A slo blo fuse blowing on F1 of the power supply board. I replaced the fuse with another and it seems to work well for only about a day, then it blows again. What do I need to check that ties into this circuit? The fuse holder looks toasty at one lug as well. Not sure if this matters and would need to be replaced.

I had a friend replace the fuse holder. He also replaced the rectifier and the male cn8 pins as well. When I went back to installit, I noticed a previous owner had replaced the cn8 female connector and added wire to each existing wire for some reason. I noticed a burnt connector from this handywork. I repinned all with trifurcon pins and removed the addition wiring prior to installation. Everything is good now but time will tell if it will hold up. Hopefully, it will.