Does someone have good images of the area below the top lanes when it comes to post and screw configuration? My game seems to have some pretty liberal part substitution im not sure on

This is the area im referring to...
E35F072D-C330-4D5D-9961-8F7903A9A41A (resized).jpeg

Also is there a clear answer on the location/use of the shorter star posts called out in the manual?

Manual also calls out for a sleeve near the top saucer (j) but no idea what it could be referring to...

Anyone have a good scan of the plastic to the right of the center lane/left of the top lanes?

Or best source for the coffin decals?

Thanks Jeff. That pretty much lines up with my inferences so far. For some reason the prior folks used bands instead of post rubbers on both sides.. and I'm missing the plastic on top of the left side entirely. hopefully this ebay piece isn't too awful I ordered today.

Loved your game log on your game

So finally got my game back together for the first time and doing some play testing...

When the lock kicker fires, it hits the side of my plastic protector... should it be making it over and into the pops area?

Considering trying to shim the ramp slightly to get more air. I dont think there should be much to make the kicker fire harder...

A4F5613D-70B2-4C15-AE7B-007FF481A1A9 (resized).jpeg

Thoughts?

I also had a hard time getting the shooter rod to make good contact... the normal shooter springs i had seemed too big

Thx. I just put a single washer under the bolt at the end of the ramp and that was enough to get it jump up over the plastic every time.

Game is finally done! First System11 I've had in the house for myself...

I can say I never found a definitive answer to this. I ultimately put the posts based on the constraints of the other stuff around it (would it make the plastic tilted, etc) and just did what looked right for the mechs. It seems authoritative knowledge on this is lost.