Elvira and the Party Monsters
Bally, 1989You're currently viewing posts by Pinsider Bryan_Kelly.
Click here to go back to viewing the entire thread.
Does anyone have a link to shop out pics? In particular, I'm looking for a pic of the first layer of metal and plastic posts and the like on the top.
I'm doing a playfield swap for a friend. I took plenty of pics but there are a few things that don't seem right.
Also, not quite sure where the shorter star posts go.
Quoted from dmacy:Do these help Bryan? I'm not sure about the post heights but maybe it will be obvious in the pics.
https://pinside.com/pinball/forum/topic/elvira-and-the-party-monsters-playfield-swap-refresh
That should be perfect!
Only other question I have is, there are two longer round standoffs. One is about 1/8" shorter than the other. Can anyone tell me which is which?
Quoted from guitarded:Weird. I have one round and 2 Hex standoffs.
The Round one is located closest to the back board on / supporting the Monster Slide.
The longer of the two Hex is by the Jam Targets, also supporting the Slide.
The shortest Hex is on the right rail.
Here's a pic of a pic.
There's 3 round posts. The shortest one goes on the far right. I did a quick measure of the center and left one before I removed them and thought they were the same. One of them is 1/16" shorter than the other.
Quoted from flynnibus:I can say I never found a definitive answer to this. I ultimately put the posts based on the constraints of the other stuff around it (would it make the plastic tilted, etc) and just did what looked right for the mechs. It seems authoritative knowledge on this is lost.
I thought the same. The manual shows 4 of the shorter ones so it shouldn't be that hard to figure out.
14BA2C3D-6AAE-4381-842D-5620A32B7DD0_1_105_c (resized).jpegAnyone else have plastics like mine? Do I have an early game?
Originals on the left and new on the right.
Second pic shows how plastics like these normally mount.
Anyone have ideas on where to find L shaped mounting brackets or material to make them? Note the bottom one needs to be longer than the others.
Third pic shows two clear pieces that weren't included in the set I got. Is this normal?
B17BD02E-2C42-4EC0-9B9F-8C1CA2DB7AAE_1_105_c (resized).jpegB9CEA223-BC9C-43F8-B07E-EDD22150284B_1_105_c (resized).jpeg6F16DAF5-EAA4-49B6-9ACE-D78A826E4B30_1_105_c (resized).jpegQuoted from Pbpins:Yes, I have those plastics pictured on the left in my sample game and then the normal ones pictured on the right in my later production game and on my HEP restored game!
Good to know! I'm sure the owner will be interested in hearing that.
You're currently viewing posts by Pinsider Bryan_Kelly.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/elvira-and-the-party-monsters-club-monsterous?tu=Bryan_Kelly and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Lakeville, MN