(Topic ID: 234800)
You're currently viewing posts by Pinsider gweempose.
Click here to go back to viewing the entire thread.
Quoted from Billc479:You are correct. However, why do they need adjusted? Is the coil stop worn?
The coil stops are fine. The flippers are just sitting slightly lower than I like. I hadn't thought about divots. I guess this is a disadvantage of this kind of flipper mech vs. the pawl on a modern flipper. If they need to be replaced, can I use any standard flipper bat?
EBC flippers (resized).jpgYou were correct about the divots. I was able to slightly raise the left flipper, but the right flipper kept slipping back to its original position. I solved this problem by swapping the right flipper with the upper flipper. Since the divots were in different locations, it allowed me to adjust the right flipper to my liking. 
Quoted from Quench:Actually, your flippers were already correctly aligned. What made you think they were wrongly setup?
It's not that I necessarily thought they were wrongly setup. They were just a little too low for my liking.
Quoted from alveolus:Can’t you just grind the divots out?
I would think this could be a possible solution as well.
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider gweempose.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
