Can someone take a picture of their connector on the relay board mounted on the backside of the head “light board”... I can’t find anywhere in the manual the pin out for the 7 pin connector. My light ms are not working correctly and someone has replaced the connector with a 5 position without a key I suspect it wired wrong as well...

Any help would be appreciated

Don

C51D39F9-7F69-410D-84BE-FBF759F0BB4E (resized).jpeg

Thank you!!!

Was playing a game after repairing the connector above when this happened; I let the ball bounce from the right flipper to the left. It slowly aches over and settle here! Really it just sat there even through the ball search as I frantically fumbled for my camera...

I love pinball

7D011219-48D0-4A87-9F41-99C02DBBB24C (resized).jpeg

FCF9FB59-C300-4F34-98D6-709E2A52E65C (resized).jpeg

6.5 this was a complete restore with a CPR Playfield and Marcos Super bands on the flippers have no idea how this could be possible but it did! Pinball is like life some skill mixed with chance....

Try updating your game code. I had something similar happen with older code.

Motor is going bad I believe it uses a CCW Counter Clockwise motor. If the motor is going bad it will at times reverse causing the issue you are having.

Don

Sand the bottoms of the posts where the threaded part broke off. Drill and tap, then use a matching screw up into the post. Problem solved